More exciting
than paint, less expensive than wallpaper!
More exciting
than paint, less expensive than wallpaper!
Most first time appliers average 40-55 square feet per bag.
Textured Solutions is similar to wallpaper in that it has dye lots. Mixing dye lots is acceptable providing they are thoroughly mixed and used in the same application. To avoid any possibility of color or texture variations between bags, be sure you mix enough Textured Solutions in one mixing operation to completely cover each section, area or wall.
In application, if it appears your mixture will be short, mix the remaining necessary amount into the first mixture as soon as possible.
IMPORTANCE OF
UNDERCOATING
Textured Solutions is a water based product which can take from 24- 48 hours to dry. For this reason, it is very important to seal the surface on which Textured Solutions is being applied to prevent it from bleeding through the Textured Solutions and staining it. We HIGHLY recommend B-I-N by WM Zinsser Co. (Product Number 901 in Red & White can)
Special care must be taken on surfaces where high staining agents, such as nicotine, exist to ensure the surface is well sealed before application of Textured Solutions. Wash all surfaces with TSP cleaner unless oil based primer is required. "T.S.P." - Trisodium Phosphate. Use only white pigmented primers.
HIGH GLOSS / SEMI-GLOSS PAINT
Rough up surface by washing with TSP solution or prime
with one coat of High Quality Primer Sealer / Stain Killer (we
HIGHLY recommend B-I-N by WM Zinsser Co.).
UNPAINTED & PAINTED SURFACES
On surfaces painted with two or more coats of flat white paint, it is safe to apply Textured Solutions providing that the paint has cured for a minimum of 40 days or more and the wall has been washed to ensure it is absolutely clean.
NOTE: It is always recommended
to seal most unsealed surfaces with a High Quality Primer Sealer / Stain
Killer (we
HIGHLY recommend B-I-N by WM Zinsser Co.) before applying Textured
Solutions. In some cases, it may be necessary to apply a second coat of
primer if the first coat has not sealed the wall properly and produced a
solid white background. Speeding up the drying process by using an
oscillating fan to blow air on the wall will greatly reduce the chance of
staining due to an insufficiently primed wall.
WOOD PANELING / WOOD VENEER / RAW WOOD / CEMENT WALLS / BLOCK WALLS
a) Fill in joints and grooves with a polyfiller/Joint Compound (sanding not required)
b) Two coats of High Quality Oil Based Primer / Sealer
/ Stain Killer (allow time
to cure between coats). We
HIGHLY recommend B-I-N by WM Zinsser Co.
WALLPAPER
a) Remove wallpaper and prime surface with High Quality
Oil Based Primer Sealer / Stain Killer. We
HIGHLY recommend B-I-N by WM Zinsser Co. (Red & White can, Product No.
901)
b) If removal seems impossible, prime thoroughly with a High Quality Oil Based Primer Sealer / Stain Killer.
c) Be sure surface has solid white background.
NOTE: Failure to properly seal the surface may cause stains on Textured Solutions products!
BATHROOMS / KITCHENS
a) Avoid areas where Textured Solutions will be in
direct contact with water.
b) Average humidity will not disturb the surface of Textured Solutions
under normal conditions.
c) If extremely high humidity exists, treat wall surface with a water
repellent such as Scotch Guard thoroughly, after Textured Solutions has
dried completely.
We look forward to answering your questions
and stand ready to fill your order!
We
ship via 
Click to view UPS Transit Times to Commercial
Locations
Lower Burrell, PA 15068
